How To Add Oil To Porta Power
MAINTENANCE
1. Inspect hoses and connections daily. Replace
damaged components immediately with Porto-Power
Automotive Replacement Parts but.
ii. Tighten connections as needed. Employ piping thread
sealing chemical compound when servicing connections.
three. Employ only a practiced grade hydraulic oil. Avoid mixing
different types of fluid and Never use brake fluid,
turbine oil, transmission fluid, motor oil or glycerin.
Improper fluid can crusade premature failure of the
ram and the potential for sudden and immediate loss
of load. Nosotros recommend Hein-Werner HW93291 or
equivalent.
Adding oil
one. With ram fully lowered, fix pump unit in its normal,
level position. Locate and remove oil filler screw.
ii. Fill until oil is within 3/viii" of the oil filler screw hole
opening, re-install oil filler spiral.
Changing oil
For best operation and increased system life, replace
the consummate fluid supply at to the lowest degree once per twelvemonth.
1. With ram fully lowered, remove the oil filler spiral
from the pump reservoir as higher up.
two. Lay the pump on its side and bleed the fluid into a
suitable container.
Notation: Dispose of hydraulic fluid in accordance with
local regulations.
3. Set pump in its level upright position.
iv. Fill with skillful quality jack oil to within iii/eight" of the oil
filler screw hole opening. Reinstall oil filler screw.
Lubrication
A blanket of low-cal lubricating oil to pivot points and
hinges volition help to prevent rust and clinch that pump
assemblies motility freely.
6
Cleaning
Periodically bank check the pump piston and ram for signs
of rust or corrosion. Clean every bit needed and wipe with
an oily cloth.
Note: Never use sandpaper or annoying material on
these surfaces!
Storage
When not in use, store with the pump piston and ram
fully retracted.
How to remove faulty coupler:
If ram does not retract,:
1. Secure load by other means.
ii. Depressurize pump and hose
three. Remove the ram from application.
4. Disconnect and replace with new coupler.
Important: Do not attempt to grasp ram with pliers or
wrench without starting time wrapping the jaws of such tool with
rags or similar padding.
How to bleed air from arrangement:
1. Place pump at a higher elevation than the hose and
ram as shown in effigy iii below.
2. Operate pump to fully extend and retract the ram 2
or iii times. The objective is to strength the air bubbling
upwardly hill and back to the pump reservoir.
iii. To bleed the air from pump reservoir, simply open up
the oil filler screw. Re-install after haemorrhage.
Effigy iii - Illustration to bleed air from organisation
How To Add Oil To Porta Power,
Source: https://www.manualsdir.com/manuals/58192/blackhawk-porto-power-b65115-porto-power-b65114.html?page=6
Posted by: massasady1977.blogspot.com
0 Response to "How To Add Oil To Porta Power"
Post a Comment